Rukus Wireless ZoneFlex 7731 Guía de usuario descargar pdf (Pagina 113)

105

Managing the Access Point

Resetting the Access Point to Factory Defaults

Figure 53. The Maintenance > Reboot/Reset page

After approximately one minute, you should be able to log back into the AP, which

verifies that the reboot was successful. You can also check the LEDs on the AP to verify

the status of the device.

Resetting the Access Point to Factory

Defaults

WARNING: DO NOT reset the Access Point to factory defaults unless you are

directed to do so by Ruckus Wireless support staff or by a network administrator. Do

this only if you are able to immediately reconnect the restored AP to your computer,

to reconfigure it for Wi-Fi network use — as detailed in “

Installing the Access Point”

on page 21

You can use the Web User interface to restore an inoperative AP to its factory default

settings, which will completely erase the configuration currently active in the device.

Note, too, that this will disrupt all wireless network communications through this

device.

To reset the Access Point to factory defaults

1. Go to Maintenance > Reboot/Reset. The Maintenance > Reboot/Reset page

appears.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 119 120

Sin comentarios

Rukus Wireless ZoneFlex 7731 Guía de usuario Pagina 113