
66
Configuring the Access Point
Configuring Wireless Settings
5. Click Update Settings to save and apply the changes. A confirmation message
appears at the top of the page.
6. Click Go back to Wireless Configuration to reopen the previous page.
Using WPA
Wi-Fi Protected Access (WPA) and Wi-Fi Protected Access II (WPA2) are two security
protocols developed by the Wi-Fi Alliance in response to the weaknesses of WEP.
Selecting WPA as the Encryption Method allows you to choose WPA version, WPA
Authentication and WPA Algorithm. This section discusses WPA-PSK (pre-shared key).
For information on WPA-Enterprise (WPA-802.1X), see “Customizing 802.1X Settings”
on page 69
.
Use of WPA-PSK (also known as WPA-Personal) allows automatic key generation
based on a single passphrase. WPA-PSK provides strong security for home and small
offices and does not require a RADIUS server, but may not be supported on older
wireless devices. In some cases, the older devices can be upgraded with adapters to
take advantage of WPA-PSK.
If you configure the WLAN with WPA-PSK, wireless users will not be able to connect
to your WLAN unless their devices support WPA-PSK and are configured with the
same passphrase.
Authentication Mode Open is the only authentication mode
available with WEP encryption.
Encryption Strength • 64 bit: Specify the key with 10 hexadecimal
digits or 5 ASCII characters.
• 128 bit: Specify the key with 26
hexadecimal digits or 13 ASCII characters.
The 128-bit cryptography is stronger
privacy protection for your network and is
recommended if you use WEP.
Key Entry Method • Hexadecimal: The encryption key only
accepts hexadecimal characters (0-9, A-F).
• ASCII Text: The encryption key accepts
ASCII characters.
WEP Key Enter the key manually according to the Key
Entry Method and Encryption Strength
settings.
Key Index Choose the index, from “1” to “4”, that the
WEP key is to be stored in.
Comentarios a estos manuales