Rukus Wireless ZoneFlex 7731 Guía de usuario descargar pdf (Pagina 37)

Installing the Access Point

Step 1: Preconfigure the Access Point

1. Connect the Access Point to a Power Source

1. Connect the power jack to the power connector on the rear panel of your ZoneFlex

Access Point.

2. Connect the power adapter to a power source.

3. Verify that the power LED on the Access Point is green.

You have completed connecting the Access Point to a power source.

NOTE: If using PoE, you do not need to connect a power adapter to the AP. Simply

provide PoE power to the to the port labeled “10/100/1000 PoE” and connect the

PoE injector/switch to the same subnet as ZoneDirector.

NOTE: If using PoE and Gigabit Ethernet, ensure that you use Cat5e or better

Ethernet cables.

2. Connect the Access Point to the Same Subnet as

ZoneDirector

1. Connect one end of an Ethernet cable to a LAN (RJ-45) port on the rear panel of

the Access Point.

2. Connect the other end of the Ethernet cable to the same Layer 2 subnet as

ZoneDirector. The same Layer 2 subnet means that there should not be any router

between the Access Point and ZoneDirector.

3. Log into the ZoneDirector Web interface, and then go to the Monitor > Access

Points page.

4. Look for the MAC address of the Access Point, and then check its Status column.

• If automatic approval is enabled, the Status column should show Connected.

• If automatic approval is disabled, click the Allow link that is on the same

row as the Access Point’s MAC address. This allows the Access Point to register

with ZoneDirector.

When the Status column shows Connected, this indicates that the Access Point has

successfully registered with ZoneDirector and that it can now be moved to its

destination Layer 2 or Layer 3 network.

3. Disconnect the Access Point from the Power Source

1. Disconnect the Access Point from the power source.

2. Verify that the power LED on the rear panel of the Access Point is off.

3. Continue to “Connect the Access Point to the Network” on page 37.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 119 120

Sin comentarios

Rukus Wireless ZoneFlex 7731 Guía de usuario Pagina 37