Rukus Wireless ZoneFlex 7731 Guía de usuario descargar pdf (Pagina 46)

Installing the Access Point

Step 2: Verify Access Point Operation

• Windows XP: In the system tray, right-click the (Wireless Network Connec-

tion) icon, and then click View Available Wireless Networks.

• Windows 7: Left click the icon.

3. In the list of available wireless networks, click the network with the same SSID as

you configured in “Configure Wireless # Settings”

on page 34. For example, if you

set the SSID to Ruckus Wireless AP, click the wireless network named Ruckus

Wireless AP.

4. Click Connect.

Your wireless client connects to the wireless network. After the wireless client connects

to the wireless network successfully, the wireless client icon in the system tray changes

to (on Windows XP) or (on Windows 7).

Check the LEDs

Perform a spot-check using the LEDs to verify that the Access Point is operating

normally. Refer to the following sections for information on how to check the LEDs on

each ZoneFlex AP model.

Single Radio APs (ZoneFlex 2942/7942/7341/7343)

If the single radio Access Point is operating normally and your wireless client was able

to associate with it:

■ The WLAN LED is green.

■ If you do not have Ruckus Wireless ZoneDirector on the network, the DIR LED is

off. This indicates that the Access Point is operating in standalone mode. If there

is a ZoneDirector device on the network, the DIR LED is green.

Dual Radio APs (ZoneFlex 7363 and 7962)

If the dual radio Access Point is operating normally and your wireless client was able

to associate with it:

■ The 2.4G or 5G LED is green.

■ If you do not have Ruckus Wireless ZoneDirector on the network, the DIR LED is

off. This indicates that the Access Point is operating in standalone mode. If there

is a ZoneDirector device on the network, the DIR LED is green.

Check the TR069 Status (FlexMaster Management

Only)

If you configured the Access Point to report to a FlexMaster server on the network,

make sure you verify that it can successfully communicate with the FlexMaster server.

You can do this by checking the TR069 status on the Access Point’s Web interface.

1. Log in to the Access Point’s Web interface.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 119 120

Sin comentarios

Rukus Wireless ZoneFlex 7731 Guía de usuario Pagina 46