Rukus Wireless ZoneFlex 7731 Guía de usuario descargar pdf (Pagina 83)

Configuring the Access Point

Configuring Ethernet Ports

The Ethernet Ports configuration page allows you to define how the Access Point’s

Ethernet ports behave. You can disable ports entirely, define trunking and packet

forwarding behavior, configure 802.1X authentication settings, and configure VLAN

settings for each port individually from this page.

Figure 38. The Configuration > Ethernet Ports page

To configure LAN ports

1. Go to Configuration > Ethernet Ports.

2. Review the following table and make changes as needed for each of the ports

labeled PORT 1 through PORT 4 (depending on AP model), which correspond to

the AP’s Ethernet ports.

Setting Description

Enable All Ethernet ports are enabled by default.

Unchecking this box next to a port disables that

port entirely. If you do not want to provide wired

access through the AP, uncheck (clear) the Enable

box next to each LAN port.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 119 120

Sin comentarios

Rukus Wireless ZoneFlex 7731 Guía de usuario Pagina 83